Amazone UF 1201, Operating Manual

Page: 125 / 220

Commissioning
3. The number of magnets required should be
calculated as follows:
Calculation:
Wheel circumference
[cm]
= Number of magnets
60 cm
Example:
256 cm
= 4.27 = min. 5 magnets
60 cm
4. Fit the sensor (Fig. 110/3) to the axle stub
on the tractor's front wheel – behind the ax-
le when viewed in the direction of travel -
using a universal holder (Fig. 110/4).
7.5.2 Installation on a tractor with all-wheel drive or an Mb-trac
•
Only fit the magnets in a place which is not subject to angular
displacement from the cardan shaft.
•
Set the gap between the magnet and the sensor in the range
between 5 and 10 mm.
•
The sensor must project at least 25 mm from the holder.
1. Secure the magnets (Fig. 111/1) to the car-
dan shaft with the hose clip (Fig. 111/2).
2. Secure the sensor (Fig. 111/3) to the vehi-
cle frame opposite the magnet using a uni-
versal holder (Fig. 111/4).
Fig. 103
UF BAG0012.11 04.19 125