Amazone GreenDrill GD200-E, Operating Manual

Page: 79 / 106

GreenDrill control terminal 5.2
GreenDrill BAH0108-0 03.20
79
Continuous or occasional
forward speed display: 0.0
km/h The speed signal is not being detected
Set the signal in section 7.1.3 to NO, if all of the settings in the
following sections are set to AUTO:
section 7.1.3,
section 7.1.4 and
section 7.1.5 (see
"Entry of the radar sensor signal source" and
"Entry of the working position sensor signal source")
The spread rate (kg/ha or
grains/m
2
) is not displayed
Calibrate the seed
(see section 6.6,
page
57)
The GreenDrill is spreading
too much or too little seed

Correct the speed

Calibrate the speed sensor
(see section 6.7,
page
63).

Not required with GPS device.

Check the hectare counter
(see section 6.8,
page
67)

Calibrate the seed
(see section 6.6,
page
57)

Lifting unit sensor not correctly set
switches over during operation

Only hydr. fan:
Reduce the fan speed
The pressure in the oil return
flow may is greater than
10 bar

Check the return flow of the hydraulic hose line on the tractor
(see section "Connecting the hydraulic hose lines to the
tractor", page 48)

Use a larger return flow line

Use a larger hydraulic coupling

Use a new return line filter