Basic settings by your AMAZONE service partner
90
GreenDrill BAH0108-0 03.20
Entry of the working position sensor signal source
The control terminal receives
the "Working/transport position]" signal
from the working position sensor (see section 6.18.4.2,
page
83).
YES, NO or AUTO
Change the parameters using the
buttons.
In working position, the working position sensor sends
HI or LO
Change the parameters using the
buttons.
Note:
On some tractors, the lifting unit signal is inverted. Invert the lifting
unit signal if the GreenDrill is e.g. seeding in transport position.
7.1.6
Acoustic warning signal
In case of an error message during operation,
an acoustic warning signal is emitted ................ON
no acoustic warning signal is emitted .............. OFF
Change the parameters using the
buttons.
7.1.7
Seeding shaft gearbox motor
The GreenDrill with 8 outlets has a ....................... P8 motor
The GreenDrill with 16 outlets has a ..................... P16 motor
Change the parameters using the
buttons.
Note:
GreenDrill GD200 have a P8 motor.
Summary of Contents for GreenDrill GD200-E
Page 2: ......
Page 32: ...Structure and function 32 GreenDrill BAH0108 0 03 20 4 1 1 6 Seed metering wheel table ...
Page 105: ......
