Amada Miyachi Unitek STA-100A, Operation Manual, Page: 51 / 154

CHAPTER 4: OPERATING INSTRUCTIONS
STA SERIES AC CONTROLS
990-351 4-3
Pre-Operational Setup
NOTES:

If your unit is equipped with a
PROGRAMMING
lock, the key must be inserted and turned to the
ON position before any program changes can be made.

If your weldhead does not have a retraction switch to control this function, a jumper must be
installed between RETR and RETC inputs on the main board.

During set-up, the following symbols indicate which values are controllable, and which are
presented for information only. The symbols are screen-specific; a value that can be controlled
on one screen may be informational on another screen.

=
are values that can be set by the operator.


are values provided for information only and cannot be changed by the operator

Following this section is a display of information and error screens, which you might encounter
during set-up.