Amada Miyachi Unitek STA-100A, Operation Manual, Page: 130 / 154

APPENDIX J: COMMUNICATION OPTION
STA SERIES AC CONTROLS
J-14 990-351
NAME COMMAND DATA SIZE
MONITOR “MS” Set <ACK> OR <NAK> 0 Bytes
MONITOR “MR” Read
SCHEDULE # 1 Byte
HIGH1C # High current #1 % 2 Bytes
LOW1C # Low current #1 % 2 Bytes
HIGH2C # High current #1 % 2 Bytes
LOW2C # Low current #1 % 2 Bytes
ANGLE LIMIT 1 Conduction limit #1 1 Byte
ANGLE LIMIT 2 Conduction limit #2 1 Byte
LIMIT # Weld count limit 2 Bytes
START start value 1 Byte
MODE weld mode 1 Byte
LOP, Low Pressure Limit (0-9999) 2 Bytes
HIP, High Pressure Limit 2 Bytes
VOLTHIW1 W1 High Volt Limit (0.00-9.99) 2 Bytes
VOLTLOW1 W1 Low Volt Limit 2 Bytes
VOLTHIW2 W2 High Volt Limit 2 Bytes
VOLTLOW2 W2 Low Volt Limit 2 Bytes
27 Bytes Total
-------------------------------------------------------------------------
weld mode: SPOT = 0
or REPEAT = 1
or SUCCESSIVE = 2
or CHANING = 3
-------------------------------------------------------------------------
start value: MAINTAINED = 0
or PULSED = 1
or LATCHED = 2
or SEAM = 3
STATUS “TS” Read Last Major Error (see below) 2 Byte
Last Minor Error (see below) 2 Byte
Schedule, Monitor, or Valve changed
0=No Change, Schedule #+1 if changed 1 Byte
Stepper, 0=No change, Valve # if changed 1 Byte
Link Array 0=No change, 1=change 1 Byte
Active screen number 1 Byte
Active screen value 1 Byte
9 Bytes Total