CHAPTER 3: OPERATING INSTRUCTIONS
SERIES 300 FAST RESPONSE WELD HEAD SYSTEM
990-115
3-3
The HELP Screens
The Weld Head Control offers you context-sensitive, on-line help screens. They are available when the
system is either running or is being programmed. To access the related help screen, all you need to do is
press the [HELP] key; an on-line screen will appear with narrative explaining the function that is currently
in effect.
For example, if you are setting up the electrode
upstop position, the upstop program screen will be
accessed.
From the alphanumerical RUN screen, press
[PROG] twice. The SET THE UP-STOP
POSITION screen appears.
Now, press the [HELP] key. The related on-line
help screen will appear to give you more
information about setting the upstop position. To
return to the set upstop screen, press [HELP] again.
Press [RUN] to return to the alphanumerical RUN
screen.
A Closer Look at the PROGRAM Screens
Press the [PROG] key to enter the program mode. Repeatedly pressing the [PROG] key cycles the display
through five programming screens. Each screen is updated with the programming changes, regardless of
which screen is used to enter the schedule information.
SET THE UP-STOP POSITION
SET THE UP-STOP POSITION WHERE THE
HEAD NORMALLY STAYS.
USE
▲
TO MOVE THE HEAD UP
USE
▼
TO MOVE THE HEAD DOWN.
CURRENT UP-STOP POSITION: .300 inch
▲▼
Adjust, PROGRAM SEARCH POSITION
[HELP] – – [SET UP-STOP POSITION]
USE
▲
/
▼
TO MOVE THE HEAD UP/DOWN TO
THE DESIRED UP-STOP POSITION. PRESS
►
TO GO TO THE NEXT STEP.
MAX RANGE: .006 - .99 IN (.2 - 25.4mm)
HELP to return
Summary of Contents for 300 Series
