CHAPTER 2: GETTING STARTED
SERIES 300 FAST RESPONSE WELD HEAD SYSTEM
990-115
2-3
Optional L-Stand Installation
NOTE:
The L-Stand Adapter contains a completely-assembled L-stand, adapter plate (P/N 4-33273-
01), and lower electrode holder. The Ship Kit contains the necessary mounting hardware.
Referring to figure 2-2, perform the following steps.
1
Lay the L-stand on its back. This will prevent the T-nuts (P/N 465-208) from moving during the
next few steps.
2
Remove the two M8-
1.25 x 25mm bolts (P/N
160-047) and 5/16 flat
washers (P/N 755-044)
securing the adapter
plate to the L-stand.
3
Secure the actuator to
the adapter plate with
four ¼-20 x ¾ flat head
Phillips screws (P/N
625-595).
4
Re-install the adapter
plate to the T-slot nuts
in the L-stand with the
bolts and washers
removed in step 2.
5
Install the assembly to a
horizontal work surface
that provides firm (non-
deflectional) support
using two T-slot nuts
(P/N 465-208), M8-1.25
x 50mm studs (P/N 625-
578), 5/16 flat washers
(P/N 755-044), and M8
nuts (P/N 465-208),
contained in the Ship
Kit.
6
Adjust the height of the
upper electrode holder
above the lower electrode holder to allow for no more than 1.06 in. (27mm) of upper electrode
travel.
7
Adjust the lower electrode holder so that any misalignment between the upper and lower electrodes
is less than 10% of the
smallest
electrode diameter or width dimensions.
T-slot nut (P/N 465-208) (2Pl)
Adapter plate
M8-1.25 x 25mm bolt (P/N 160-047)
and 5/16 flat washer (P/N 755-044) (2Pl)
1/4-20 x 3/4 flat head Phillips
screw (P/N 625-595) (4Pl)
Upper electrode holder
T-slot nut (P/N 465-208) (2Pl)
M8-1.25 nut (P/N 465-206) and
5/16 flat washer (P/N 755-044)
(2Pl)
Lower electrode holder
Work bench (ref)
M8-1.25 x 50mm stud
(P/N 625-578) (2Pl)
Figure 2-2. Optional L-Stand and Lower Electrode Holder
Installation
Summary of Contents for 300 Series
