AMA Instruments The GC 5000 BTX, Operating Manual, Page: 99 / 152

Operating Manual GC 5000 BTX; Version 5 – 11/2010 97
Calibration file (CAL) Misc options tab Perform an update:
The following window pops up:
How to process new calibration data subsequently from an already
acquired chromatogram:
The relevant data input is displayed in the window above.
1. Specify the correct calibration level in the field „
Level to update “.
2. Select one the three radio buttons on the left which determine the type
of update.
3. Click on one of the two radio buttons on the right. Select whether the
new data shall be used or whether the old and the new data shall be
averaged.
4. Select the name of the corresponding chromatogram in the field „ Bound
File Name ”.
5. Click onto „ OK “.
The data has been produced.
6. Select
Component tab
On this tab you can check the new retention times and/or the new
response values.
7. At last the component table shall be saved again by
clicking Menu item File Save
The data has been saved.
11.3.14 Module setup
Menu bar Parameter Module setup
In this menu you can configure connected AMA Instruments modules like a
sample stream selector, a dilution module or a permeation module.
The module setup is described in detail in chapter 9.2.3.
Subsequent
calibration