Operating Manual GC 5000 BTX; Version 5 – 11/2010
73
11.3 Parameters
In this menu item you can edit parameters like temperatures or times.
Menu bar
Parameter
Select between the following parameters:
•
Change password
•
Operation mode
•
Remote control
•
Master mode
•
Method
•
Analysis
•
GC oven
•
Calibration
•
Validation setup
•
Analog output configuration
•
CP Analysis
•
CP File Editor
•
Module setup
11.3.1 Change password
Menu bar
Parameter
Change password
When you click on “Change password” the earlier described input box pops
up (see chapter 11.4.1).
Enter the new code and click onto “E”.
The new password is active now.
11.3.2 Operation mode
Menu bar
Parameter
Operation mode
In this menu item you can select between three different modes:
•
“Manual operation”:
The analyzer starts one run after clicking onto the “Start” button and
waits for the next click onto the “Start” button.
•
“Cyclic mode”:
The analyzer starts the next cycle after the specified cycle time.
•
“Remote control”:
The analyzer waits for a new cycle start via the communication protocol
after each run.
Summary of Contents for The GC 5000 BTX
Page 1: ...Operating Manual Gas chromatograph GC 5000 BTX...
Page 35: ...Operating Manual GC 5000 BTX Version 5 11 2010 33 Fig 5 Connection of analog outputs...
Page 102: ...Operating Manual GC 5000 BTX Version 5 11 2010 100 Injection Waiting for end of cycle time...
Page 105: ...Operating Manual GC 5000 BTX Version 5 11 2010 103 Injection Waiting for end of cycle time...