AM General M915A1, Technical Manual

Page: 319 / 757

TM 9-2320-283-20-3
3-252. GENERAL.
Section XVI. CAB AND BODY
This section provides procedures authorized at the organizational maintenance
level to replace cab and body components. To find a specific procedure
contained in this section, see the task summary below.
3-253. TASK SUMMARY.
INITIAL SETUP
EQUIPMENT CONDITION
APPLICABLE CONFIGURATIONS PARAGRAPH CONDITION DESCRIPTION
All.
(Refer to specific paragraph for this
information).
TEST EQUIPMENT
None.
SPECIAL TOOLS
hone.
MATERIALS/PARTS (P/N)
Solvent, drycleaning, SD-2
Rivet, blind, 3/16 in., (30)
Item 29, Appendix C.
(11815) SSLQ-64.
Adhesive, rubber, type II Rivet (36)
Item 1, Appendix C. (11815) SSLQ-66.
Rag, wiping Rivet, blind (30)
Item 22, Appendix C.
(05693) SSLQ-64.
Retainer, quarter-turn screw (9)
Insulation (as required)
(94222) 85-34-101-20.
Rivet, blind (14)
(35623) M/164-20000 (right-hand and
left-hand center back panel).
(05693) SSPV086. (34623) M/164-20001 (upper back panel).
Caplug (as required)
(34623) M/164-20002 (lower back panel).
(34623) MA207-20059. (34623) M/164-20003 (corner back panel).
Clip, insulation fastener (34623) M/164-20004 (rear side panel).
(as required)
(85105) 101-301-104.
(34623) M/164-20017 (center back panel).
(34623) M/164-20018 (roof).
Rivet, blind, l/4 in., (40) Rivet (as required)
(19738) 2771-0817.
(11815) SSP-42.
Rivet, blind, l/16 in., (10)
(11815) SSLQ-66.
PERSONNEL REQUIRED SPECIAL ENVIRONMENTAL CONDITIONS
Three (MOS-63S). None.
3-1492