83
ACCESSORY CONTROL MODULE (ACM) -
REMOVAL & INSTALLATION
1.
Remove the seat and the left- and right-side shrouds
).
2.
Remove the battery (
3.
Remove the Charge Port Shroud. The Charge Port
Shroud rear screws secure the rear of the ACM as well.
4.
Swing open the connector lock levers. (
Fig. 4
)
5.
Remove the plug from the top of the ACM. (
Fig. 5
)
6.
Remove the remaining ACM mounting screws.
7.
Move the ACM forward and disconnect
the connectors.
8.
Make sure the connector seal on the main harness
connector is seated properly (
A
) and has not shifted
on the connector body. Note: After installing the
plug into the ACM, the harness seal should not be
visible. If it is visible, the seal has spun and needs to
be repositioned.
9.
Maneuver the ACM into position and connect the
main harness electrical connector. Swing the
connector lock levers shut, and make sure it clicks
into place. Reinstall the plug into the top of the ACM.
(
Fig. 6
)
10.
Line-up the holes, and install the ACM forward
mounting screws. Make sure the rear screw holes
are aligned as well, and tighten the forward screws
to 8 Nm.
11.
Install the Charge Port Shroud (
).
12.
Install the battery (
).
13.
Install the shrouds and the seat (
Fig. 4
Fig. 5
Fig. 6
HIGH VOLTAGE BATTERY AND DRIVE SYSTEM
