Alta Motors Redshift MX 2017, Owner'S Service Manual

Page: 36 / 122

36
RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS
1. Remove the three mud flap-to-rock guard screws.
Please take note of which spacer goes where.
2. To install, reverse the removal procedure, and take
note of the following:
• Install the center mud flap screw/compression
limiter first and tighten it to 2 Nm.
• Install the two outer screws/compression limiters
and tighten them to 2 Nm.
1. Remove the subframe (
SEctioN 5
), and the mud flap
(
SEctioN 7
).
2. Remove the number plates (
SEctioN 6
).
3. Remove the remaining rock guard screws and washers.
MUD FLAP - REMOVAL & INSTALLATION ROCK GUARD -
REMOVAL & INSTALLATION
CHAPTER 2