Alta Motors Redshift MX 2017, Owner'S Service Manual

Page: 103 / 122

103
RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS RETURN TO TABLE OF CONTENTS
LEFT-SIDE BEARING
8. Remove the motor and countershaft assembly if it
has not been already (
SEctioN 13
).
9. Remove the countershaft seal from the left side of
the RBH (
SEctioN 8
).
10. Remove the snap-ring from the seal/bearing bore.
11. Remove the bearing from the bore with a slide
hammer and puller attachment. Alternatively, drive it
out from the right to the left with a hammer and long
drift. If the latter method is used, work slowly, working
around the circumference of the bearing a little at a
time so as not to distort the bore in the RBH.
12. Clean the bearing bore, and drive the new bearing
into place with a bearing driver until it is seated.
13. Lubricate the bearing with the specified gear oil.
14. Install the snap-ring, making sure it is fully seated.
16. Install the countershaft seal (
SEctioN 8
), motor and
countershaft assembly (
SEctioN 13
).
HIGH VOLTAGE BATTERY AND DRIVE SYSTEM