115
THROTTLE SWITCH / TUBE -
REMOVAL & INSTALLATION
1.
Remove the key from the ignition switch.
2.
Remove the number plate/headlight housing
).
3.
Cut the zip-ties that bundle the harnesses together,
and follow the switch harness to its electrical connector.
Unplug the connector from the main harness.
4.
Cut the zip-ties that secure the switch harness to
the handlebar.
5.
Loosen the throttle switch screw and slide the
throttle tube/switch off the handlebar. There are two
screws that bolt the throttle housing halves together,
and one single screw that releases the housing from
the bar.
6.
To install, reverse the removal procedure, noting
the following:
• Slide the switch/throttle tube onto the handlebar,
leaving a 5 mm gap between the throttle switch and
the Start/Stop/Run switch. The chamfer on the end
of the throttle tube should be positioned just inward
of the end of the handlebar (approximately 1 mm). If
the placement of the throttle isn’t correct relative to
the brake master cylinder, the lever operation will
be blocked and thus create a large safety concern.
Always check the brake lever functionality after
installing the throttle.
• Tighten the switch screw to 2 Nm.
• Secure the wiring harness to the handlebar with
new zip-ties. Note: Keep the wires routed along the
underside of the handlebar. Trim the zip-ties with
flush cutters.
• Install the number plate/headlight housing
).
• Install a new grip if necessary, such as if it has
been removed or a new throttle switch/tube is
being installed.
LOW VOLTAGE ELECTRICAL
