Alstom MiCOM P50 Agile P15D, Technical Manual

Page: 47 / 224

P50 Agile P15D
5 Configuration
P15D/EN TM/B 5-11
OC/EF Relay
ID = 001 V1.03
This window will flash momentarily showing the following
Relay Type: OC/EF Relay Software Version: V1.03
Unit ID = 001
Then the control will go automatically to default window
A=0000 A
B=0000 A
This window shows actual Primary load current as per the CT Primary
selection.
Press the Left arrow key (

) or the Right arrow key (

) to return to the
Main Menu.
MEASUREMENTS
2.3.2 Main Menu Contents
MEASUREMENT
This menu is to view the Measurement parameters .
Press the Plus / up arrow key (+ /

) to move to the next option.
CB CONTROL
Password protected window for “CB CONTROL” setting. i.e. Trip Test
Enable / Disable, Trip Block Enable / Disable and Latch Relay Enable /
Disable.
Press the Plus / up arrow key (+ /

) to move to the next option.
DATE AND TIME
Password protected window for “DATE AND TIME’’ setting i.e. Local
Time Enable, SET Year, SET Month, SET Date, SET Seconds, SET
Minutes, SET Hours, RP Time Zone, DST End minutes, DST End Month
DST End Day, DST End, DST start minutes DST start Month, DST start
Day, DST start, DST Offset, DST Enable and Local Time Offset.
Press the Plus / up arrow key (+ /

) to move to the next option
CONFIGURATION
Password protected window for “CONFIGURATION’’ settings i.e.
Restore Defaults, Under Current Protection Enable / Disable, Measure’t
Setup, Cold Load Pickup Enable/Disable, Thermal Overload Enable /
Disable, Earth Fault Enable/ Disable, Over current Enable / Disable,
System Configuration Enable /Disable, Setting Value, Setting Group 1,
Setting Group 2 and Active Settings.
Press the Plus / up arrow key (+ /

) to move to the next option
CT AND VT RATIOS
Password protected window for “CT AND VT RATIO ’’ setting Ph CT
Primary and E/F CT Primary
Press the Plus / up arrow key (+ /

) to move to the next option.