Alstom MiCOM P50 Agile P15D, Technical Manual

Page: 39 / 224

P50 Agile P15D
5 Configuration
P15D/EN TM/B 5-3
1 CHAPTER OVERVIEW
This chapter consists of the following sections:
1 Chapter Overview
2 Configuration
2.1 Changing the settings
2.2 Procedure for changing the setting of Parameters
2.2.1 General procedure for changing setting of any parameter (with alphabetic value)
2.2.2 General procedure for changing setting of any parameter (with numerical value)
2.3 MENUS
2.3.1 Default Display
2.3.2 Main Menu Contents
2.3.3 MEASUREMENT MENU
2.3.3.1 View contents
2.3.4 CB CONTROL MENU
2.3.4.1 Edit settings
2.3.4.2 View settings
2.3.5 DATE AND TIME MENU
2.3.5.1 Edit settings
2.3.5.2 View settings
2.3.6 CONFIGURATION MENU
2.3.6.1 Edit settings
2.3.6.2 View settings
2.3.7 CT & VT RATIOS MENU
2.3.7.1 Edit settings
2.3.7.2 View settings
2.3.8 RECORD CONTROL MENU
2.3.8.1 Edit settings
2.3.9 COMMUNICATION MENU
2.3.9.1 Edit settings
2.3.9.2 View settings
2.3.10 GROUP 1 MENU
2.3.10.1 Edit settings
2.3.11 GROUP 1 –SYSTEM CONFIGURATION SUB MENU
2.3.11.1 Edit settings (if 2nd Harmonic is disabled)
2.3.11.2 Edit settings (If 2nd Harmonic is enabled)
2.3.12 GROUP 1 – OVERCURRENT SUB MENU
2.3.12.1 Edit settings (if I>1 function is disabled)
2.3.12.2 Edit settings (if I>1 function is selected for IEC curves)
2.3.12.3 Edit settings (if I>1 function is selected for IEEE Curves)
2.3.12.4 Edit settings (if I>1 function is selected for DT i.e. Definite Time)
2.3.13 GROUP 1 EARTH FAULT SUB MENU
2.3.13.1 Edit settings (if IN>1 function is disabled)
2.3.13.2 Edit settings (if IN>1 function is selected for IEC curves)
2.3.13.3 Edit settings (if IN>1 function is selected for IEEE Curves)
2.3.13.4 Edit settings (if IN>1 function is selected for DT i.e. Definite Time)
2.3.14 GROUP 1-THERMAL OVERLOAD SUB MENU
2.3.14.1 Edit settings (if Thermal Overload function is disabled)
2.3.14.2 Edit settings (if Thermal Overload function is Single)
2.3.15 GROUP 1 -COLD LOAD PICKUP SUB MENU
2.3.15.1 Edit settings (Protection Menu)