94
-EN
Installation
Caution concerning the installation location
1
Before installing, make sure that the opening and
closing of the display will not interfere with
operation of the gear shift.
2
Angle of installation
About the installation angle, please install as
horizontally as possible within the following angle
range. If the installation angle is beyond the range,
the current position may not be correctly displayed
and a maloperation may be caused for the
navigation mode.
3
Remove the mounting sleeve from the main unit (see
“Removal” on page 95).
The unit can be installed in the mounting sleeve in
three positions by aligning its mounting holes (A to
C) on the sides of the unit. Position A will be used in
most cases. If B or C are to be used, the hole
positions need to be modified.
First, determine the mounting position in the
mounting sleeve, then affix the supplied seal (refer
to “How to use a Seal” (page 95)).
Slide the unit into the mounting sleeve and secure it.
•
If B or C is used, make sure that there is a enough space depthwise
before installing the unit. If the unit is forcibly pushed into the
mounting sleeve, damage may occur.
*
1
If the installed mounting sleeve is loose in the dashboard, the
pressure plates may be bent slightly to remedy the problem.
Caution
Do not block the unit’s fan or heat sink, thus preventing
air circulation. If blocked, heat will accumulate inside
the unit and may cause a fire.
Air ventilation hole
Rear of the Unit
Movable Display
Front of the unit
Top of the unit
10°(±5°)
0°
0-30°
Side of the unit
<Mounting Hole Position>
Position A
Position B
Position C
•
Depending on the position chosen, the front panel will protrude
differently.
Position A
Position B
Position C
Mounting Sleeve
(Included)
Dashboard
This unit
Seal
(Included)
Face Plate
*
2
(Included)
Pressure
Plates
*
1
Rubber Cap (Included)
Bracket
Hex Bolt
(Included)
Front Panel
Dashboard
Front Panel
Dashboard
Front Panel
Dashboard
