47
-EN
You can set the system to be unusable without entering a password.
When you set this setting to On and set a password, the password input
is required when the system is connected to a battery and turned on for
the first time.
Setting item: Security code
Setting contents: On / Off
Setting the password
1
Touch
[On]
.
2
After the confirmation message appears, touch
[Yes]
.
The password setting screen is displayed.
3
Enter a password, then touch
[OK]
.
•
Enter the 6-digit number.
•
Input numbers are displayed as “*”.
4
Enter the same password again, then touch
[OK]
.
The password is set and the system returns to the General
Setup screen.
•
If you forget a registered password, you can not use this unit. In this
case, service will be required.
Clearing the password
1
Touch
[Off]
.
The password setting screen is displayed.
2
Enter the password you have set, then touch
[OK]
.
The password is cleared and the system returns to the
General Setup screen.
•
Input numbers are displayed as “*”.
System Setup Operation
1
Press
SOURCE/
on the unit.
The Source Select screen is displayed.
2
Touch
[
]
on the main source screen.
The Setup Select screen is displayed.
3
Touch
[
]
of System Setup.
The System Setup screen appears.
4
Touch
[
]
or
[
]
etc., of the desired item to change
its setting.
Setting items:
Remote Sensor
*
/ Camera IN / AUX1 IN / AUX2 IN / AUX Out /
BLUETOOTH IN / Optical Out / Speed Pulse / Rear Source
*
* When ON is set in “Setting the Picture Output” (page 49), the item is
displayed.
5
Touch
[
]
to return to the previous screen.
Touch
[
Exit]
to return to the main source screen that was
displayed before the setup operation was started.
•
Immediately after changing the settings of System Mode (While the
system is writing data automatically) do not turn the ignition key
(engine key) to OFF. Otherwise, the settings may not be changed.
For remote control operation, the remote sensor of the external device
(monitor, etc.) can be switched, as you prefer.
Setting item: Remote Sensor
Setting contents: Front / Rear
•
When an optional DVD changer or DVD player is connected, and the
remote control sensor is set to Rear, some onscreen button operations
(
[
]
Stop, etc.) cannot be performed. In this case, set the remote
control sensor to Front.
Setting Security code
System Setup
The Parking Brake must be engaged to access the System mode
screen. Attempting to access this screen while driving will display
the warning-Can’t operate while driving.
The following steps 1 to 5 are common operations to each
“Setting item” of System Setup. Refer to each section for details.
Switching the function of the remote
sensor
Front:
The remote sensor of this unit is effective.
Rear:
The remote sensor of the external monitor
connected to AUX OUT of this unit becomes
effective. The remote control operates the
source connected to the AUX OUT terminals.
