7
-EN
Getting Started
Turning Power On and Off
Press
SOURCE/POWER
to turn on the unit.
• The unit can be turned on by pressing any other button except
TITLE and eject
c
.
Press and hold
SOURCE/POWER
for at least 2
seconds to turn off the unit.
• The first time power is turned on, the volume will start from level 12.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first
time, after installing the CD changer, after changing the car battery, etc.
1
Turn off the unit power.
2
Press
RESET
with a ball-point pen or similar
pointed object.
Setting Time
1
Press
MENU
.
2
Select SETUP by sliding your finger on the
GlideTouch bar
to the left or right. Press the
GlideTouch bar
under SETUP.
The main SETUP menu is displayed.
3
Select GENERAL by sliding your finger on the
GlideTouch bar
to the left or right.
Press the
GlideTouch bar
under GENERAL.
The GENERAL SETUP menu is displayed.
4
Select CLOCK by sliding your finger on the
GlideTouch bar
to the left or right. Press the
GlideTouch bar
under CLOCK.
5
Select “Hour” by sliding your finger on the
GlideTouch bar
to the left or right.
6
Adjust “Hour” by turning the
Rotary encoder
.
7
Adjust “Minute” by turning the
Rotary encoder
by repeating steps 5 and 6.
8
After setting, press and hold
MENU
for at least 2
seconds to return to normal mode.
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold the
Rotary encoder
for at least 2
seconds after setting the “hour.” Minutes will reset to 00.
If the display shows over “30” minutes when you do this, the time
will advance one hour.
• If
MENU
is pressed while adjusting or setting the items in the
MENU mode, the unit will return to the previous selection screen.
• By pressing the
GlideTouch bar
under RETURN in the MENU
mode, the unit will return to the normal mode.
• If no operation is performed for 60 seconds, the unit will return to
the normal mode.
Opening and Closing the Movable Display
Press
c
.
The movable display will open.
To close the movable display, press
c
again.
The movable display will close.
• Do not apply shock to the movable display when it is open as it
may result in malfunction of the unit.
• The display may be dim during low temperatures and immediately
after turning on the power. The brightness will return to normal as
time elapses.
• The display will stop at the set tilt angle when closing.
Caution
Keep hands (or any other object) away from the display while it
is opening or closing to avoid damage or injury. The back of the
movable display will get very warm under normal operating
conditions. This is not a malfunction. Do not touch.
SOURCE/
POWER
RESET
Rotary encoder
MENU
GlideTouch bar
c
MUTE
