Table C
— System Status Menu
LCD display
Meaning
Description
INV (min)
Amount of time
inverter was on
shows total time in minutes the inverter has been active since the last time
inverter timer was cleared. See INV RECORD description in Table B
SHED TIMER1
Amount of time
until the dry
contact is
activated.
The factory default dry contact for this setting is contact C4. SHED
TIMER2 and SHED TIMER3 can be field
programmed. See “Setting the
Timer Contact”. This display shows the amount of time left in seconds
until the contact is activated. The factory default setting is 2 hours, but this
can be changed as shown in "Programming the Dry Contacts and the
Clock". C4 is available on the FXM350 if the optional signal assembly is
installed
—see Section 3.3.2.
SHED TIMER2
SHED TIMER3
MAC Address
Communication
Module's MAC
The Communication Module's MAC address is displayed.
IP Address
Communication
Module's IP
The Communication Module's IP is displayed.
kWh
kWh Meter
The accumulated output energy is displayed.
Remain Tm
Remaining
Battery
Runtime
The remaining runtime of the battery is displayed. Refer to Appendix A to
set battery parameters.
Serial Number
Unit Serial
Number
The unit serial number of the Alpha FXM is displayed.
VERSION
Software
Version
The software version used in this Alpha FXM
7.2.5
Viewing the 200-event Log
Using the LCD display, or web interface, you can view up to the last 200 events the Alpha FXM went through and
the malfunctions that triggered each of them. If more than 200 events occurred, the oldest is overwritten. To clear
this log, see “Operating the Alpha FXM, INV RECORD.”
To view the events on the LCD display, refer to the following procedure.
Page
4
7
to
106
Summary of Contents for FXM 350 Series
Page 1: ...Alpha FXM Series 350 USER MANUAL...
Page 21: ...Page 20 to 106...
