C613-50102-01 REV C
Command Reference for x510 Series
299
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
P
LUGGABLES
AND
C
ABLING
C
OMMANDS
SHOW
SYSTEM
FIBER
-
MONITORING
Related
Commands
Table 8-1: Parameters in the output from
show system fiber-monitoring
Parameter
Description
Reading units
The units for optical power readings in the rest of the
display, e.g. 0.0001mW.
Status
Whether active fiber monitoring is enabled or disabled for
this port.
Supported
Whether the pluggable inserted in this port supports
active fiber monitoring.
Debugging
Whether debugging of active fiber monitoring is enabled
or disabled for this port.
Interval
The configured interval between readings of optical
power on this port.
Sensitivity
The configured sensitivity threshold for optical power
changes on this port.
Baseline type
How the baseline optical power level is calculated: either
the average of the specified number of previous readings
or a specified fixed value in 0.0001mW.
Status
Current values for the following parameters.
Baseline value
The baseline value, calculated according to the configured
baseline method, in 0.0001mW.
Alarm threshold
The current threshold for a change in optical power,
calculated according to the configured sensitivity method,
that will result in action.
Alarm
Whether the optical power at the most recent reading
fallen below the threshold.
Last 12 readings
The last 12 optical power values measured, in 0.0001mW,
with oldest value first.
Minimum reading
The lowest optical power reading since the fiber
pluggable was last inserted, or since active fiber
monitoring was last enabled on the port.
Maximum reading
The highest optical power reading since the fiber
pluggable was last inserted, or since active fiber
monitoring was last enabled on the port.
