C613-50102-01 REV C
Command Reference for x510 Series
1366
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
PIM-DM C
OMMANDS
IP
PIM
HELLO
-
HOLDTIME
(PIM-DM)
ip pim hello-holdtime (PIM-DM)
Overview
This command configures a
hello-holdtime
. The PIM
hello-holdtime
on a VLAN
interface is the period which the router will wait to receive a hello from neighbors
on that interface. If the router does not receive a hello from a given neighbor
within that period, then it will decide that the neighbor is no longer an active PIM
Router, and will terminate the neighbor relationship.
You cannot configure a
hello-holdtime
value that is less than the current
hello-interval
. Each time the
hello-interval
is updated, the
hello-holdtime
is also
updated, according to the following rules:
•
If the
hello-holdtime
is not configured; or if the hello holdtime is configured
and less than the current
hello-interval
value, it is modified to 3.5 times the
hello-interval
value.
•
Otherwise, it retains the configured value.
Use the
no
variant of this command to return the hello-holdtime value to its
default of 3.5 times the current hello-interval value.
Syntax
ip pim hello-holdtime <holdtime>
no ip pim hello-holdtime
Mode
Interface Configuration for a VLAN interface.
Example
awplus#
configure terminal
awplus(config)#
interface vlan2
awplus(config-if)#
ip pim hello-holdtime 123
Parameter
Description
<
holdtime
>
<1-65535>
The holdtime value in seconds (no fractional seconds are accepted).
