Allied Telesis AT-x510-28GPX, Command Reference Manual

Page: 2400 / 2601

C613-50102-01 REV C Command Reference for x510 Series 2400
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
LLDP C
OMMANDS
LLDP MED
-
TLV
-
SELECT
Default By default LLDP-MED Capabilities, Network Policy, Location Identification and
Extended Power-via-MDI TLVs are enabled. Therefore, if LLDP is enabled using the
lldp run command, by default LLDP-MED advertisements are transmitted on ports
that detect LLDP-MED neighbors connected to them.
Mode Interface Configuration
Usage LLDP-MED TLVs are only sent in advertisements via a port if there is an
LLDP-MED-capable device connected to it. To see whether there are LLDP-MED
capable devices connected to the ports, use the
show lldp neighbors command.
Examples To enable inclusion of the Inventory TLV Set in advertisements transmitted via
ports 1.0.1 and 1.0.6, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# lldp med-tlv-select inventory-management
To exclude the Inventory TLV Set in advertisements transmitted via ports 1.0.1 and
1.0.6, use the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# no lldp med-tlv-select inventory-management
To disable LLDP-MED advertisements transmitted via ports 1.0.1 and 1.0.6, disable
all these TLVs using the commands:
awplus# configure terminal
awplus(config)# interface port1.0.1,port1.0.6
awplus(config-if)# no lldp med-tlv-select all
inventory-management
Inventory Management TLV Set, including the following
TLVs:
• Hardware Revision
• Firmware Revision
• Software Revision
• Serial Number
• Manufacturer Name
• Model Name
• Asset ID
all
All LLDP-MED Organizationally Specific TLVs.
Parameter Description