C613-50102-01 REV C
Command Reference for x510 Series
1134
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
IGMP
AND
IGMP S
NOOPING
C
OMMANDS
IP
IGMP
QUERY
-
MAX
-
RESPONSE
-
TIME
ip igmp query-max-response-time
Overview
Use this command to configure the maximum response time advertised in IGMP
Queries.
Use the
no
variant of this command to restore the default.
NOTE
:
The IGMP query maximum response time must be less than the IGMP query
interval.
Syntax
ip igmp query-max-response-time <
response-time
>
no ip igmp query-max-response-time
Default
The default IGMP query maximum response time is 10 seconds.
Mode
Interface Configuration for a VLAN interface.
Usage
This command applies to interfaces configured for IGMP.
Note that the IGMP query interval is automatically set to a greater value than the
IGMP query maximum response time.
For example, if you set the IGMP query interval to 3 seconds using the
command, and the current IGMP query interval is less than 3
seconds, then the IGMP query maximum response time will be automatically
reconfigured to be 2 seconds, so it is less than the IGMP query interval time.
To get the network to converge faster, use the
ip igmp
query-max-response-time
command and set a low response time value, such as
one or two seconds, so that the clients will respond immediately with a report as a
response to the IGMP Queries.
Examples
To set a maximum response time of
8
seconds for vlan20, use the following
commands:
awplus#
configure terminal
awplus(config)#
interface vlan20
awplus(config-if)#
ip igmp query-max-response-time 8
To reset the default maximum response time to the default (10 seconds) for vlan10,
use the following commands:
awplus#
configure terminal
awplus(config)#
interface vlan10
awplus(config-if)#
no ip igmp query-max-response-time
Parameter
Description
<
response-time
>
Response time value in seconds, in the range 1-3180.
