60549
71
Section 8 Service Procedures Unique to Electronic Control Model Dryers
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
• If branch circuit to dryer is 15 feet (4.50m) or
less in length, use U.L. (Underwriters
Laboratories) listed No. 10 A.W.G. wire
(copper wire only), or as required by local
codes. If over 15 feet (4.50m), use U.L.
(Underwriters Laboratories) listed No. 8
A.W.G. wire (copper wire only), or as
required by local codes. Allow sufficient
slack in wiring so dryer can be moved from
its normal location when necessary.
• The power cord (pigtail) connection between
wall receptacle and dryer terminal block is
NOT supplied with dryer. Type of pigtail
and gauge of wire must conform to local
codes and with instructions mentioned in
previous paragraph.
• The method of wiring the dryer is optional
and subject to local code requirements. Refer
to Figure 53.
b. Electrical Connection (Three-Wire)
IMPORTANT: This dryer is grounded to neutral
conductor at the terminal block. If the dryer is
installed in a mobile home, or if local codes do not
permit grounding through the neutral, proceed as
shown on Pages 76 and 77.
(1) Remove the screw and terminal block
access cover from the rear of dryer cabinet.
(2) Insert ends of wires through power supply
hole (containing proper strain relief) in rear
of dryer cabinet. Refer to page 75. Connect
the power cord, or direct wiring, to the
appropriate terminal block terminals as
follows:
Through Serial No. S6271975XG–Use
the nuts and washers from the accessories
pack in the envelope shipped inside the
dryer cylinder.
Starting Serial No. S6271976XG–Use the
three-wire binding (10-32x3/8") screws
from the accessories pack in the envelope
shipped inside the dryer cylinder.
If the dryer had previously been connected
with a four-wire power cord, remove the
four-wire cord by reversing procedures
under four-wire power cord. Refer to pages
76 and 77.
IMPORTANT: Use only a new U.L. listed No. 10
(copper wire only) three conductor power supply
cord kit rated 240 Volts (minimum) 30 Amperes
and labeled as suitable for use in a clothes dryer.
(3) Through Serial No. S6271975XG–
Tighten these outer nuts firmly using a 3/8"
deep well socket.
Starting Serial No. S6271976XG–Tighten
these wire-binding screws firmly.
IMPORTANT: Failure to tighten either the nuts or
screws firmly may result in wire failure at the
terminal block.
(4) Secure the strain relief to the power cord, or
wires, where they enter the dryer cabinet.
(5) Reinstall access cover and screw.
To reduce the risk of electric shock,
disconnect the electrical service to the
dryer before proceeding.
W135
WARNING