Alliance Laundry Systems NetMaster HC18NC2, Programming Manual

Page: 86 / 146

Programming NetMaster
F232152
84 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
92. Rinse Final Fill/Tumble
Dispenser “+092”
This option allows the owner to select which dispenser
will be used for Final Rinse on all cycles.
How to Program Rinse Final Fill/Tumble
Dispenser
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-) keypad
until “
PrOg
” appears in the VFD. Press the START
(enter) keypad and “
+001
” will appear in the VFD.
Figure 141
3. Press the DELICATES (+) or the COLD (-) keypad
to scroll through the programmable options until
“
+092 ” appears in the VFD. Refer to Figure 142.
Figure 142
4. When “
+092
” appears in the VFD, press the
START (enter) keypad. A number will appear in
the VFD. This number corresponds to the current
Rinse Final Fill/Tumble Dispenser Programming
Value.
NOTE: The number appearing in the VFD is the
current number that was selected from Table 19 on
the following page.
5. Locate the desired number in the first column of
Table 19 on the following page.
NOTE: Default Rinse Final Fill/Tumble Dispenser
value is 006.
6. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current
number until correct. Refer to Figure 143.
Figure 143
7. Press the START (enter) keypad when the correct
number appears in the VFD. The next option,
“
+093
”, will appear in the VFD.
NOTE: To program “
+093
” (PreWash #1 Fill/
Tumble Drain), refer to option 93. To program
other options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
COM135N
COM135N
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
3 2