Alliance Laundry Systems NetMaster HC18NC2, Programming Manual

Page: 78 / 146

Programming NetMaster
F232152
76 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
88. PreWash #2 Fill/Tumble
Dispenser “+088”
This option allows the owner to select which dispenser
will be used for PreWash #2 on all cycles.
How to Program PreWash #2 Fill/Tumble
Dispenser
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-) keypad
until “
PrOg
” appears in the VFD. Press the START
(enter) keypad and “
+001
” will appear in the VFD.
Figure 129
3. Press the DELICATES (+) or the COLD (-) keypad
to scroll through the programmable options until
“
+088 ” appears in the VFD. Refer to Figure 130.
Figure 130
4. When “
+088
” appears in the VFD, press the
START (enter) keypad. A number will appear in
the VFD. This number corresponds to the current
PreWash #2 Fill/Tumble Dispenser Programming
Value.
NOTE: The number appearing in the VFD is the
current number that was selected from Table 15 on
the following page.
5. Locate the desired number in the first column of
Table 15 on the following page.
NOTE: Default PreWash #2 Fill/Tumble Dispenser
value is 001.
6. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current
number until correct. Refer to Figure 131.
Figure 131
7. Press the START (enter) keypad when the correct
number appears in the VFD. The next option,
“
+089
”, will appear in the VFD.
NOTE: To program “
+089
” (Wash Fill/Tumble
Dispenser), refer to option 89. To program other
options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
COM131N
COM131N
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
3 2