Alliance Laundry Systems NetMaster HC18NC2, Programming Manual

Page: 82 / 146

Programming NetMaster
F232152
80 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
90. Rinse #1 Fill/Tumble Dispenser
“+090”
This option allows the owner to select which dispenser
will be used for the Initial Rinse on all cycles.
How to Program Rinse #1 Fill/Tumble
Dispenser
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-) keypad
until “
PrOg
” appears in the VFD. Press the START
(enter) keypad and “
+001
” will appear in the VFD.
Figure 135
3. Press the DELICATES (+) or the COLD (-) keypad
to scroll through the programmable options until
“
+090 ” appears in the VFD. Refer to Figure 136.
Figure 136
4. When “
+090
” appears in the VFD, press the
START (enter) keypad. A number will appear in
the VFD. This number corresponds to the current
Rinse #1 Fill/Tumble Dispenser Programming
Value.
NOTE: The number appearing in the VFD is the
current number that was selected from Table 17 on
the following page.
5. Locate the desired number in the first column of
Table 17 on the following page.
NOTE: Default Rinse #1 Fill/Tumble Dispenser
value is 003.
6. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current
number until correct. Refer to Figure 137.
Figure 137
7. Press the START (enter) keypad when the correct
number appears in the VFD. The next option,
“
+091
”, will appear in the VFD.
NOTE: To program “
+091
” (Rinse Extra Fill/
Tumble Dispenser), refer to option 91. To program
other options, refer to the appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
COM133N
COM133N
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
3 2