Alliance Laundry Systems NetMaster HC18NC2, Programming Manual

Page: 53 / 146

Programming NetMaster
51
F232152 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
73. Special Wash Rinse Extra Fill/
Tumble Time “+073”
This option allows the owner to set the amount of time
for an extra rinse fill/tumble in the Special Wash cycle.
How to Program Special Wash Rinse Extra
Fill/Tumble Time
1. Control must be in Manual Mode. Refer to
Entering the Manual Mode.
2. Press the DELICATES (+) or the COLD (-)
keypad until “ PrOg ” appears in the VFD. Press
the START (enter) keypad and “ +001 ” will
appear in the VFD.
Figure 93
3. Press the DELICATES (+) or the COLD (-)
keypad to scroll through the programmable
options until “
+073
” appears in the VFD. Refer
to Figure 94.
Figure 94
4. When “
+073
” appears in the VFD, press the
START (enter) keypad. The current number of
minutes set for the Special Wash Rinse Extra Fill/
Tumble Time will appear in the VFD.
5. Press the DELICATES (+) or the COLD (-)
keypad to increase or decrease the current
number of minutes displayed in the VFD to the
desired number of minutes. Refer to Figure 95.
NOTE: The Special Wash Rinse Extra Fill/Tumble
Time can be set from zero (0) to 15 minutes.
Figure 95
6. Press the START (enter) keypad when the correct
number of minutes appears in the VFD. The next
option, “
+074
”, will appear in the VFD.
NOTE: To program “
+074
” (Special Wash Rinse
Final Fill/Tumble Time), refer to option 74 in
Programming NetMaster in the Basic Programming
Guide. To program other options, refer to the
appropriate section.
How to Exit Programming Feature
1. Be sure the control shows a programmable option,
not a value.
2. While pressing and holding the NORMAL
keypad with one hand, press the PERM PRESS
keypad with the other hand. The control will
revert back to the Ready Mode.
C762I
COM121N
COM121N
B029R
1 Press this pad (+) to scroll forward or increase a value
2 Press this pad (enter) to choose a selected value or
option
3 Press this pad (-) to scroll back or decrease a value
neednew#2
1
3 2