53264
33
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
36. INNER AND OUTER DOOR PANELS AND
DOOR HANDLE
Refer to Figure 20
a. Remove loading door. Refer to Paragraph 27.
b. Remove two hex head screws holding handle to
door.
37. DOOR STRIKER
Refer to Figure 20
a. Remove two hex head screws holding handle to
door.
b. Spread door panels just far enough to depress
tabs on top and bottom of striker and push out
of inner panel.
38. DOOR SEAL
Refer to Figure 20
a. Open loading door and remove seal from inner
door panel.
NOTE: When replacing seal, be sure seal is not
stretched or distorted. Use a heat resistant adhesive
(such as Krazy Glue
®
) to adhere door seal to inner
door panel.
39. LINT FILTER
Refer to Figure 19
a. Open loading door and lift filter out of air duct.
40. STRIKER CATCH
a. Remove front panel. Refer to Paragraph 31,
steps “a” and “c”.
b. Depress tabs on top and bottom of catch and
push out of front panel. Refer to Figure 21.
Figure 20
DRY850S
HINGE
INNER
DOOR
PANEL
DOOR
SEAL
DOOR
STRIKER
OUTER
DOOR PANEL
DOOR
HANDLE
