53264
43
Section 5 Service Procedures
To reduce the risk of electric shock, fire, explosion, serious injury or death:
• Disconnect electric power to the dryer(s) before servicing.
• Close gas shut-off valve to gas dryer(s) before servicing.
• Never start the dryer(s) with any guards/panels removed.
• Whenever ground wires are removed during servicing, these ground wires must be
reconnected to ensure that the dryer is properly grounded.
W001R1
WARNING
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
59. CYLINDER BELT
a. Remove front panel. Refer to Paragraph 31,
steps “a” through “c”.
b. If present, disconnect cylinder light wires at
connectors.
c. Remove four hex head screws holding
bulkhead to front flange of cabinet. Then lift
complete bulkhead assembly out of slots in
cabinet. Refer to Figure 33.
d. Disengage belt from motor and idler pulleys.
Refer to Figure 35.
e. While supporting cylinder, carefully remove
belt off cylinder.
NOTE: When installing belt, be sure belt is
properly positioned around cylinder and on motor
and idler pulleys. Refer to Figure 35.
60. CYLINDER ASSEMBLY
a. Remove front panel. Refer to Paragraph 31,
steps “a’ through “c”.
b. If present, disconnect cylinder light wires at
connectors.
c. Remove four hex head screws holding
bulkhead to front flange of cabinet. Then lift
complete bulkhead assembly out of slots in
cabinet. Refer to Figure 33.
d. Disengage belt from motor and idler pulleys.
Refer to Figure 35.
e. Remove two cabinet top hold-down screws.
Refer to Figure 26.
f. Carefully remove cylinder out through front of
dryer.
NOTE: When reinstalled cylinder, be sure belt is
properly positioned around cylinder and on motor
and idler pulleys. Refer to Figure 35.
Figure 34
DRY861S
FELT
SEAL
TAPE
SPRING
SEAL STRAP
(Installed with
cupped surface
against seal)
Seal must be
positioned under
flanged edge
CYLINDER GLIDE
ATTACHING SCREW
Figure 35
DRY862S
MOTOR
PULLEY
IDLER
PULLEY
BELT
