Allen-Bradley 1394 SERCOS, User Manual

Page: 32 / 301

Publication 1394-5.0 — May 2000
2-2 Installing Your 1394 (applies to all systems)
The product described in this manual is intended for use in an
industrial environment.
To meet CE requirements, the following additions are required:
• You must run three-phase input wiring in a conduit that is
grounded to the enclosure.
• You must install a power line filter (Allen-Bradley catalog
number SP-74102-006-01, SP-74102-006-02, SP-74102-006-03
or equivalent based on system current) between the three-phase
input line and the system module input.
• You must terminate the shields of the motor power cables and the
motor feedback cables to the enclosure at the point of entry.
Low Voltage Directive
These units are tested to meet Council Directive 73/23/EEC Low
Voltage Directive. The
EN 60204-1 Safety of Machinery-Electrical
Equipment of Machines, Part 1-Specification for General
Requirements
standard applies in whole or in part.
Refer to Appendix B for interconnect information.
Before Mounting Your System
Before you mount your 1394 system make sure you understand the
following:
• how to store your 1394 before installation
• how to unpack the system and axis modules
• the minimum mounting requirements
• how to determine your mounting hole layout
Storing Your 1394 Before Installation
The 1394 System module and Axis modules should remain in their
shipping containers prior to installation. If the equipment is not to be
used for a period of time, store it as follows:
• Store the equipment in a clean, dry location that is not exposed to
a corrosive atmosphere.
• Do not store equipment in a construction area.
• Store within an ambient temperature range of 0 to 65
°
C
(32
to
149°
F).
• Store within a relative humidity range of 5 to 95%,
noncondensing.