Alaxala AX3630S, Software Manual

Page: 855 / 875

40. Error Messages Displayed When Editing the Configuration
827
Cannot attach this list because flow detection
mode layer3-6.
If the receiving-side flow detection mode is
layer3-6
, the access list
cannot be applied.
If the flow detection mode is
layer3-6
, IPv4 and IPv6 access lists can be
applied to the VLAN interface.
To do so, you can use the following commands:
ip access-group
command
ipv6 traffic-filter
command
Cannot attach this list because flow detection
out mode layer3-1-out. If the sending-side flow detection mode is
layer3-1-out
, the access list
cannot be applied.
If the sending-side flow detection mode is
layer3-1-out
, IPv4 access lists
can be applied to the Ethernet interface.
To do so, you can use the following command:
ip access-group
command
Cannot attach this list because flow detection
out mode layer3-2-out.
If the sending-side flow detection mode is
layer3-2-out
, the access list
cannot be applied.
If the sending-side flow detection mode is
layer3-2-out
, MAC, IPv4,
and IPv6 access lists can be applied to the Ethernet interface.
To do so, you can use the following commands:
mac access-group
command
ip access-group
command
ipv6 traffic-filter
command
Cannot attach this list because flow detection
out mode layer3-3-out. If the sending-side flow detection mode is
layer3-3-out
, the access list
cannot be applied.
If the sending-side flow detection mode is
layer3-3-out
, MAC, IPv4,
and IPv6 access lists can be applied to the VLAN interface.
To do so, you can use the following commands:
mac access-group
command
ip access-group
command
ipv6 traffic-filter
command
Cannot set policy based routing entry
because specified destination address is
invalid.
The entry cannot be set because policy-based routing does not support the
destination address specified as a filtering condition.
If you use IPv4 policy-based routing, specify for the destination address an
IP address that is not a multicast address, restricted broadcast address, or
internal loopback address.
Cannot set policy based routing entry
because specified source address is invalid.
The entry cannot be set because policy-based routing does not support the
source address specified as a filtering condition.
If you use IPv4 policy-based routing, specify for the source address an IP
address that is not a multicast address or internal loopback address.
Cannot set TCP/UDP port range entry
because flow detection mode layer3-6. If the flow detection mode is
layer3-6
, a range of TCP/UDP port numbers
cannot be specified.
Configure an access list that does not specify a range of TCP/UDP port
numbers.
Over two entry as an address family cannot
be set.
Another access list has already been applied.
If you want to apply an access list, first delete the existing access list that
has already been applied.
Range-Start must be less than Range-End. The start value of a range specification is not smaller than the end value.
For range specifications, make sure that the start value is smaller than the
end value.
Message Description