Alaxala AX3630S, Software Manual

Page: 144 / 875

9. Ethernet
116
frame-error-notice
Sets the condition for sending a notification when a frame reception error or a frame sending error
occurs. A frame reception error or a frame sending error indicates that a frame is discarded due to
a failure in receiving or sending a frame, which is caused by a minor error. The cause of the failure
is collected as statistics. If the number of error occurrences or the error occurrence rate over 30
seconds exceeds the value set by using this command, the error occurrences are reported. The
settings of this command are applied to all ports of the Switch, and the sending side and the
receiving side have the same settings.
If this configuration is not set, the error occurrences are reported when 15 or more errors occur in
a 30-second interval.
The following table shows the list of statistical items that correspond to frame reception and frame
sending errors.
Table 9-2: List of statistical items
If an error occurrence is reported, a log entry is displayed and a private trap is issued. For details
about the log, see the manual Message and Log Reference For Version 11.7 . For details about
private traps, see the manual MIB Reference For Version 11.7 .
Syntax
To set or change information:
frame-error-notice [error-frames <frames> ] [error-rate <rate> ] [{ one-time-display |
everytime-display | off }]
Note: At least one parameter must be specified.
To delete information:
no frame-error-notice
Input mode
(config)
Parameters
error-frames <frames>
Sets, as the error notification condition, the threshold for the number of error occurrences
(number of error frames).
1.
Default value when this parameter is omitted:
15
2. Range of values:
1 to 446400000
# Statistical item
Receiving Sending
1 • CRC errors
• Alignment
• Fragments
•
Jabber
• Symbol errors
•
Short frames
• Long frames
• Late collision
• Excessive collisions
• Excessive deferral