Alaxala AX3630S, Software Manual

Page: 239 / 875

13. Spanning Tree Protocol
211
spanning-tree link-type
Sets the link type of the applicable port. This command is applied to the applicable ports of all
Spanning Tree Protocols (PVST+, Single Spanning Tree, and Multiple Spanning Tree). If you want
to change the high-speed topology when
rapid-pvst
or
mst
is set by the
spanning-tree mode
command, and
rapid-pvst
is set by the
spanning-tree vlan mode
command, the connection
between bridges must be a point-to-point connection. If you want to change the high-speed
topology when
rapid-stp
is set by the
spanning-tree single mode
command, the connection
between bridges must be a point-to-point connection.
Syntax
To set or change information:
spanning-tree link-type { point-to-point | shared }
To delete information:
no spanning-tree link-type
Input mode
(config-if)
Parameters
{ point-to-point | shared }
If
point-to-point
is set, point-to-point connection is used for the link type. If
shared
is set,
a shared connection is used for the link type.
1.
Default value when this parameter is omitted:
This parameter cannot be omitted.
2. Range of values:
point-to-point
or
shared
Default behavior
point-to-point
is used for a full-duplex port and
shared
is used for a half-duplex port.
point-to-point
is applied to a virtual link set when both Spanning Tree Protocols and the Ring
Protocol are used together.
Impact on communication
None
When the change is applied
The change is applied immediately after setting values are changed.
Notes
1. The automatic restoration functionality is enabled if
point-to-point
is set in STP
compatibility mode. The automatic restoration functionality does not operate if
shared
is set
in STP compatibility mode.
2. This command is not applied to a virtual link set when both Spanning Tree Protocols and the
Ring Protocol are used together.
Related commands
spanning-tree mode
spanning-tree vlan mode