Alaxala AX3630S, Software Manual

Page: 865 / 875

40. Error Messages Displayed When Editing the Configuration
837
40.1.21 DHCP snooping information
Table 40-21: DHCP snooping error messages
40.1.22 GSRP information
Table 40-22: GSRP error messages
<server address> : Indicates the IP address of an authentication server.
fense: duplicate vlan subnet address
<subnet address> and subnet mask
<subnet mask> .
That subnet address and mask have already been set elsewhere.
<subnet address> : Indicates the subnet address of an authenticated VLAN.
<subnet mask> : Indicates the subnet mask of an authenticated VLAN.
fense: Inconsistency is found between the
dot1x and the fense configuration.
Authentication VLAN-related commands cannot be executed if IEEE
802.1X command
dot1x system-auth-control
has been set.
fense: Inconsistency is found between the
vlan suspend the fense vlan configuration.
The MAC VLAN used for an authentication VLAN cannot be suspended.
Conversely, a suspended MAC VLAN cannot be used for an authentication
VLAN.
fense: the set of VLAN ID <vlan id> and
subnet is different from configured set.
The subnet you set for a VLAN ID is different from the subnet that has
already been set for the VLAN ID.
The subnet corresponding to a VLAN ID must not change for a VAA ID.
<vlan id> : Indicates the VLAN ID of an authenticated VLAN.
Message Description
Cannot change the configuration because
there is an inconsistency between flow
detection mode and ip verify source.
A conflict occurred between the terminal filter setting and the flow
detection mode setting.
To set a terminal filter, specify the following flow detection mode:
•
layer3-dhcp-1
The VLAN target of the DHCP snooping and
ARP inspection is not suitable.
The target VLAN settings for DHCP snooping and dynamic ARP
inspection are invalid.
The target VLAN for dynamic ARP inspection must be a VLAN subject to
DHCP snooping.
Message Description
can not configure gsrp when spanning-tree is
configured.
GSRP cannot be set because the Spanning Tree Protocol has been set.
can not configure gsrp when virtual-router is
configured. GSRP cannot be set because VRRP has been set.
Cannot set layer3-redundancy command
when no ip routing command exists.
Layer 3 redundancy switching cannot be set because the
no ip routing
command is set.
Change
no ip routing
to
ip routing
, and then execute the
layer3-redundancy
command.
gsrp- <gsrp group id> : can not configure
layer3-redundancy when GSRP ID is not in
range from 1 to 4.
The
layer3-redundancy
command cannot be set if the GSRP group ID
is not 1, 2, 3, or 4.
Set a value from 1 to 4 for the GSRP group ID.
<gsrp group id> : Indicates the GSRP group ID.
Message Description