Alaxala AX3630S, Software Manual

Page: 843 / 875

40. Error Messages Displayed When Editing the Configuration
815
Invalid nif number. -- <value1> <value1> is outside the valid NIF number range.
Set a value within the range.
<value1> : Invalid value
Invalid port number. -- <value1> <value1> is outside the valid port number range.
Set a value within the range.
<value1> : Invalid value
Invalid Mask. -- <value1> <value1> is outside the valid subnet mask range.
Set a value within the range.
<value1> : Invalid value
Maximum number of entries are already
defined (config memory shortage). <value1>
Shared memory for the configuration is full.
Delete entries that are no longer needed, execute the
save
command, and
then add an entry.
<value1> : Entry name
Maximum number of entries are already
defined.
<value1>
An attempt is being made to set a configuration that is larger than the
capacity limit or to change a configuration in an environment already at the
maximum capacity limit.
Delete configurations that are no longer used, and then set the configuration
again.
<value1> : Entry name for the maximum capacity limit
Not found <value1> . The specified <value1> information could not be found.
Check if the <vlaue1> information has been set.
Port is not mounted -- <value1> . The number of the port which is not mounted is specified.
Set the number of the port which is mounted or check the status of the
applicable NIF and port in the Switch.
<value1> : A NIF number or a port number
Syntax error -- <value1> . The configuration syntax or the value is invalid.
Set the configuration again with the correct syntax or value.
<value1> : Invalid value
The different name is already defined. A different name is already set.
The number in which list specification is
possible is <value1> .
The maximum number of specifiable elements is <value1> .
Check if the number does not exceed the capacity limit.
<value1> : Maximum number of elements that can be specified for a list
The sequence number exceeded the
maximum value. Try "resequence"
Command.
The sequence number exceeds the maximum value.
To specify an entry, execute the
resequence
command, and then specify
this entry again.
This configuration has already been set. This configuration has already been set.
Too long value or illegal format (max
<value1> characters).
The number of characters exceeds the maximum value ( <value1> ), or an
invalid character is contained.
Use the determined format.
<value1> : Number of characters that can be entered
Too long value or illegal format (max
<value1> digit number).
The number of characters you entered exceeds the maximum number of
digits ( <value1> ), or an invalid character exists.
Use the determined format.
Message Description