securityProbe 5ESV Manual
Updated until firmware 404m
- 49 -
7. Expansion Ports
Your AKCP Securityprobe-5ESV-X20 or X60 is equipped with two expansion ports. This
enables you connect up to four daisy chains of expansion modules. The available
expansion modules are an eight port intelligent sensor board and an Opto-isolated
sixteen dry contact expansion module. In this section we will go through the basic setup
of the sensor. If you require information on specific functions of a particular sensor or
expansion board then please refer to the relevant manual for that product.
Plug the expansion unit into one of the two ports located on the front panel of the unit.
These are numbered E1 and E2.
From the summary page, navigate to the “Sensors” tab. Then click “Expansion Units” as
outlined in the image below:-