Page 23
DD8
plus Version 2.20 - September 1998
LOCATING TO TIMECODE POSITIONS
You may locate to a timecode position by pressing GOTO followed by F5 (LOCATE). Use the
track keys as a numeric keypad to enter the required time. Values enter from the right and time
divisions (i.e. hours, minutes, seconds and frames) are confirmed using the 00 ‘double zero’ soft
key (F5).
For example, to enter a value of 1 hour, 23 minutes, 12 seconds, 12 frames, type the following:
1, 00, 2, 3, 00, 1, 2, 00, 1, 2, ENTER
You will see the following display in the selected timecode field as you enter the numbers:
The important thing to remember is to ‘confirm’ the time division using the numeric keypad’s 00
‘double zero’ key.
If you wish to enter a timecode value with a sub-frame, use the procedure described above but
press the <- (F1) or -> (F2) keys to move the cursor to the sub-frame field.
LOCATING TO LOCATOR MEMORIES
To locate to a previously stored locate memory, press GOTO, F6 (MEMORY) and enter the
appropriate memory number 0-99 using the track keys (ALL/0, 1-8, SYNC/9) as a numeric key-
pad. Finally, press ENTER (see STORING LOCATE MEMORIES).
LOCATING TO THE START OR END OF A PROJECT
To locate to the START or END of a project, simply press GOTO, START (Rewind key) or GOTO,
END (Fast Forward key) and you will be taken directly to these positions.
LOCATOR - 6
