spot of land. After balancing, in the lower left corner of the screen
will display a numerical value of balance (phase), this is the amount by
which the device will adjust the VDI, excluding the effect of the soil.
It should be noted that the average phase angle ground balance is different
for each instance of the device and can also depend on the technological
variability in parameters of the coil and the ambient temperature.
However do not forget that your device remains in the automatic bal-
ancing mode and at any moment may deem it was time to rebalance to
your shovel, boots, or hunting partner. If you want to review the results
and values of the current automatic.
to enter manual mode
and disable automatic balancing.
In the upper right corner
of the screen will appear
M
instead
of the letter
A.
To exit the ground balancing, click
Switching between modes is as simple as performing
successive clicks of
While in the manual balance mode by pressing
and
one is able to adjust
Departement of international trade:
the ground balance in the proper direction.
Bob the coil vertically above the ground
(rising to 20 -30cm / dropping by 3-5cm),
making sure that the vector of the soil is
along the
horizontal axis and that the hum
is gone when raising or lowering the coil.
- Vector of improperly balanced soil (fig. 7)
- Vector of properly balanced soil (fig. 8)
(fig. 7)
(fig. 8)
20
