11
Departement of international trade:
| +74957991510 |
EXTERNAL REGULATOR INS
T
RUCTION
Only for Signum GT
All controllers are analog, that is, they work regardless of the parameters
are set in the menu.
1) There is a current switch to the coil at the bottom of the control box,
There are two positions. or 6 options for sensor current value:
a) economy \ economy - 40%
b) norms \ norms - 40%
c) Turbo \ Turbo - 40% Switching.
The “ forward” position = current state set in MENU. (economy \ norms
\ turbo) The “back” position is approximately minus 40% of the set in
the MENU.
The “back” position is applied:
a) The search on litter.
b) Mineralized soils (in combination with the program mode “Econo-
my”).
c) For the operational determination of dubious goals.
2) An additional gain control is located on the back of the body. Attention!
Gain control is NOT linear!
All gain values are given from the gain in the MENU of the device.
The minimum value is the position all the way to the left to the bottom
white point. About 25% of the Gain.
Lateral white point - 100% gain.
The maximum value when turning all the way to the right. 200% of the
gain.
Note.
The gain and device sensitivity are NOT linearly dependent.
Increasing the gain by 2 times - the sensitivity by 2 times will NOT in-
crease! Warning:
Turning the gain control may cause short beeps. This is not a defect.
