Departement of international trade:
47
about 4 seconds per wiring in one direction. Speed can be reduced or
increased depending on the situation. Sensor wiring is carried out at a
height of 20cm to 1m depending on the “A” filter settings and the
density / magnitude of the surface metal debris under which targets are
searched.
The usual scanning height above the ground at the places of late set-
tlements, according to the experience of the operators, is 60-70 cm,
smoothly avoiding sharp pushes when starting the back movement of
the sensor, as well as significant changes in the scanning height during
wiring. If there is a software version with this program, it is located un-
der №4 in the list of factory programs. Also, any program can be con-
figured as a deep one by turning on the DP mode in the Settings Menu>
Search Options> Search terms. The transition to program №4 is carried
out both by sequentially sorting factory programs by pressing a
button
and by holding the button from any other work pro-
gram.
In the second case, a repeated long press of the button
returns
to the program from which the Deep Program was
turned on.
DEEP PROGRAM SETTINGS
Factory preset settings allow you to effectively use DP in the vast major-
ity of relevant search tasks. But with a conscious confidence in the need,
they can be adjusted for a specific task. If the operator does not under-
stand the results of the settings adjustment, as in the case of changing
any other settings of the device, if you wish, you can restore their factory
values by turning off the device and turning it on while holding the
setting button
until the inscription “Factory Settings”
appears.
* CHANGE SOUND SIGNALS DP
In DP it is possible to use three sound indications: RT, RT-M and RT-
M99 The choice of them is in the Parameter menu> Sound settings>
