36
1.3 Component Out
This parameter defines the output format of the
Component Video Output
BNC
connectors (
Composite Out
is a function of
Input Format
and the
1.3 Component Out
parameter setting).
Notes:
1.
Bypass
applies to all analog outputs (
Component
,
Composite
, and
S-Video
).
When
1.3 Component Out
is set to Bypass, Input signal format is 525i/59.94,
and
5.3 SD Aspect Ratio
is set to anything other than
Off
, the
Composite Out
and
S-Video
outputs will also bypass the Aspect Ratio Converter.
2.
Setting parameter
1.3 Component Out
to
Bypass
causes
Composite Out
to
bypass aspect ratio conversion (parameter
5.3
).
3.
As in
1.2 SDI2 Out
,
Bypass
mode is not offered in these cases (3:2 Pulldown):
1080pSF/23.98 Input / 1080i/59.94 Output
1080pSF/23.98 Input / 525i/59.94 Output
1080pSF/24 Input / 1080i/60 Output
In these cases,
Bypass
mode behaves like
Normal
mode—the output is the
same format as the main
SDI1
output.
2.1 Video Input
This parameter performs input video source selection for the FS1. Multiple input
sources may be present at all the connectors on the FS1 rear panel, but the active
input source routed through the FS1 will be the one selected here.
1.3 Component Output
Description of Choices
Parameter Adjustments:
Normal
(Default)
Bypass (Follow Input)
Standard Def
Component output follows the
1.1 Output Format
parameter selection.
Component output follows the format of the selected input.
Notes:
Bypass
mode does not work when the input is 1080pSF24 and output is
1080i60 (3:2 pulldown mode).
The signal type of the Component output (RGB versus YPbPr) is defined in another
parameter (
3.2 Component OUT Format
).
The output from Downconverter 2 (see block diagram in
Chapter 1
) is always
standard definition.
2.1 Video Input
Description of Choices
Parameter Adjustments:
SDI 1
(Default)
SDI 2
Composite
S-Video
Component
Select SDI 1 connector as the input source.
Select SDI 2 connector as the input source.
Select the Composite connector as the input source.
Select the S-Video connector as the input source.
Select the Component connector as the input source.
