1
35
FS1 Installation and Operation Manual — 1.1 Output Format
1.1 Output Format
This parameter defines the SDI 1 output format. Depending on other settings, it may
also apply to SDI 2 and the Component Video output.
Notes:
1.
Available rates that listed here depend on what has been chosen in the 3.3
Frame Rates parameter setting.
2.
If the parameter
1.1 Output Format
is set to
Follow Ref
, and the
6.1 Genlock
Source
is set to
Input
, and the
2.1 Video Input
is set to select one of the
analog inputs, then the output format will follow the input format rather
than the format of the signal on the
Ref BNC
as might be expected. (This
combination of settings effectively disconnects the
Ref BNC
.)
3.
Changing the
Output Format
selection automatically selects new values for
H & V timing parameters (
6.2 Output Timing H
,
6.3 Output Timing and
6.4 Analog Output Fine
). Each
Output Format
selection remembers its own H
& V timing settings.
1.2 SDI 2 Out Format
This parameter defines the output format on the
SDI 2 BNC
connector.
Notes:
1.
The output from Downconverter 2 (see block diagram in
Chapter 1
) is
always standard definition.
2.
Bypass
mode is not offered in these cases (3:2 Pulldown):
1080pSF/23.98 Input / 1080i/59.94 Output
1080pSF/23.98 Input / 525i/59.94 Output
1080pSF/24 Input / 1080i/60 Output
In these cases,
Bypass
mode behaves like
Normal
mode—the output is the
same format as the main
SDI1
output.
1.1 Output Format
Description of Choices
Parameter Adjustments:
Follow Input
(Default)
Follow Ref
SD <sd_rate>
HD 720p <hd_rate1>
HD 1080i <hd_rate1>
HD 1080psf <hd_rate2>
Follow the format of the selected input.
Follow the format of the reference video input (Ref).
Select standard definition (available SD rates are listed choices).
Select HD 720p (available rates are listed choices).
Select HD 1080i (available rates are listed choices).
Select HD 1080psf (available rates are listed choices).
1.2 SDI 2 Output Format
Description of Choices
Parameter Adjustments:
Normal
(Default)
Bypass (Follow Input)
Standard Def
SDI 2 output follows the
1.1 Output Format
parameter selection (both SDI outputs
are the same format).
SDI 2 output follows the format of the selected input.
The output from Downconverter 2 (see block diagram in Chapter 1) is always
standard definition.
