only cut deep enough to remove the covering and not cut into the balsa! Remove your lines with a paper towel soaked with
denatured alcohol.
18) Scuff the bottom portion of each horn and the base plate with sandpaper. Thoroughly spread 30 minute epoxy or gorilla glue
on both sides & edges of both control horns, the bottom of the base plate and some in the slots on the elevator. Insert the
assembly back in, making sure they are facing forward. Press down on the base plate to ensure a flush & tight fit. Wipe away
excess glue with a paper towel and denatured alcohol. Keep the bolt & ball link assembled to ensure alignment & spacing as it
dries. Repeat for the other elevator half. Set aside to dry.
19) Slide the joiner into the other elevator half and mark the edge of the left elevator. Remove all covering that will be inside the
slot.
Tip
: To save some time and glue, you can glue both ailerons, elevator and rudder control
horns at the same time. Be sure to read ahead and DOUBLE CHECK what side you’re cutting
for each piece (the rudder gets cut on both sides). Test fit all of the horns and glue all at
once.
