Section 2
Fuselage — Elevator/Rudder
9) Remove the fuselage and using a sharp knife, remove the covering from the areas to allow the anti-rotation pins, wing tube,
aileron extensions and wing capture bolt to pass through.
10) Also remove the covering exposing the horizontal stabilizer slot on both sides, and the hole for the elevator servo on the
LEFT side of the fuselage.
11) Test fit the horizontal stabilizer making sure it is centered and aligned to the fuselage. Use a 12” ruler to get it centered in
the fuselage. Slide the wing tube in and look at the plane from the back forward to make sure that the horizontal stabilizer is
parallel with the wing. If not, sand or shim the fuselage until level.
