Version May 2021
EN
21
agru SP 63 mobile
V 3
User’s Manual
agru Kunststofftechnik GmbH
Ing.-Pesendorfer-Str. 31
4540 Bad Hall, Austria
First, the machine asks the operator to insert the facing tool into posi-
tion 1. This is the position for clamping the components. In this position
the spacer pins of the facing tool do not sit in the recesses of the clamp
bodies in which they are during facing. Slide the facing tool in-between
the carriages of the machine in position 1 and confirm it is in place by
pressing the carriage mover button
(see the “Important” note at the
beginnig of Sect. 4.7).
When the facing tool is located between the components, with automatic
mode enabled, the machine closes the movable carriage in on the facing
tool. Without automatic mode, hold down the
carriage mover button
(see the “Impotant” note at the beginnig of Sect. 4.7)
When the mobile carriage has been moved in on the fixed one, clamp
the components to be jointed into the clamps. While the screen that
requests this of the welder can be seen, it is
possible, using the Minus and the Plus buttons,
to decrease or increase the distance the carriage
will travel during facing (see Display 10). When
the facing distance is as desired, confirm by
pressing the carriage mover button
, and the
machine moves the carriage apart for the next
process item, or, with automatic mode disabled,
hold down the
carriage mover button (see
the “Important” note at the beginnig of Sect. 4.7).
The next process item is to move the facing tool
from position 1 to position 2, the position for
facing proper. Again, the screen requests this of the welder. To move
the facing tool, release its position lock. When it sits in position 2, press
the carriage mover button
(see the “Important” note at the beginnig
of Sect. 4.7).
Info
Prior to the facing process, checking the direction and the speed
of the rotation of the power facer is recommended.
The machine then asks the welder to start the facing tool. Do as you are
requested, using the On/Off switch of the power facer, and hold down the
carriage mover button
until the machine moves the carriage apart
automatically (see Display 11). This indicates that the facing process is
correct, considering the previously set facing distance. Then switch the
facing tool off at its On/Off switch.
Info
If the mover button
is released before the carriage moves
apart, the facing tool pauses to allow for removing shavings;
holding down the
button again to resume facing.
When the machine has moved the carriage apart, the facing tool can be
removed from in-between the pipes. Visually check the components and,
if they are o.k., confirm this by pressing the
button. If the result
of facing is poor, the process can be repeated after pressing the
button. To face the ends once again, in most cases the pipes have to be
re-adjusted in the clamps.
Info
If an error occurs during facing, the machine moves the mobile
carriage apart, displaying the corresponding error message.
The facing process can be aborted at any time by pressing the
button.
Display 11
