INSTRUCTIONS FOR USE
AGS 400-1200 EN
Rev.12/2018
87
Figure 11: Tri-jet nozzle
15.3
MAINTEANCE OF SPRAYING EQUIPMENT
Periodically check screws and bolts, pins and especially safety pins, their tightness and their condition.
Tighten or replace them if necessary.
The equipment is equipped with some adjusting bolts, which need to be adjusted from time to time. To
do this, open the arms of the equipment in the working position and adjust the arms of the equipment
which must be parallel to the shoulder of the spraying equipment.
GREASING:
Grease all moving parts of your spraying equipment after every 40 working hours. The spanners on the
trapezium and the axes of the hydraulic equipment is equipped with greasers type:
Figure 12: Greasing nipple
In the case your spraying equipment is being cleaned by a high-pressure cleaning appliance, it is
recommended to grease all parts after every single cleaning.
After washing the spraying equipment, check if any of the hoses or joints leaks and check the
condition of the flexible hoses. Repair broken hoses or loose joints in good time, since that kind of
errors can cost you a lot of time during spraying.
IMPORTANT: make sure that you have attached and tightened the nuts of the
adjustment bolts after adjusting the spraying equipment.
