Agilent Technologies G7104A, User Manual

Page: 206 / 234

206 Agilent 1290 Infinity II Flexible Pump User Manual
11
LAN Configuration
Automatic configuration with Bootp
Determining the MAC address directly from the LAN Interface card label
1 Turn off the instrument.
2 Read the MAC address from the label and record it.
The MAC address is printed on a label on the rear of the module.
3 Read the MAC address from the label and record it.
The MAC address is printed on a label on the rear of the module.
See Figure 23 on page 190 and Figure 24 on page 190.
4 Turn on the instrument.
Assigning IP Addresses Using the Agilent BootP Service
The Agilent BootP Service assigns the Hardware MAC address of the
instrument to an IP address.
Determining the MAC address of the instrument using BootP Service
1 Power cycle the Instrument.
2 After the instrument completes self- test, open the log file of the BootP
Service using Notepad.
• The default location for the logfile is C:\Documents and Settings\All
Users\Application Data\Agilent\BootP\LogFile .
• The logfile will not be updated if it is open.
The contents will be similar to the following:
3
Record the hardware (MAC) address (for example, 0010835675AC).
02/25/10 15:30:49 PM
Status: BootP Request received at outermost layer
Status: BootP Request received from hardware address: 0010835675AC
Error: Hardware address not found in BootPTAB: 0010835675AC
Status: BootP Request finished processing at outermost layer