Agilent Technologies 4352B, Service Manual

Page: 284 / 293

Error Messages (Alphabetical Order)
0350 Queue overow
A specic code entered into the queue instead of the code that caused the error . This code
indicates that there is no room in the queue and an error occurred but was not recorded.
0400 Query error
This is the generic query error that the 4352B displays when it cannot detect more specic
errors . This code indicates only that a query error as dened in IEEE 488.2, 11.5.1.1.7 and 6.3
has occurred.
0410 Query INTERRUPTED
A condition causing an interrupted query error occurred (see IEEE 488.2, 6.3.2.3). F or
example , a query followed by DAB or GET before a response was completely sent.
0420 Query UNTERMINA TED
A condition causing an unterminated query error occurred (see IEEE 488.2, 6.3.2.2). F or
example , the 4352B was addressed to talk and an incomplete program message was receved by
the controller .
129 RECALL ERROR: INSTR ST A TE PRESET
A serious error , for example corrupted data, is detected on recalling a le , and this forced the
4352B to be PRESET .
49 RF Freq Out Of Range
The DUT's output frequency is not within the measurement range of the 4352B (10 MHz to 3
GHz).
V erify the DUT's output frequency .
58 RF Input Over Trans Max Freq
Indicates that the frequency transient measurement trace was probably inaccurate because the
input frequency to the 4352B was above the upper limit of the detection band.
Note , however , that \RF Input Under Trans Min Freq " (message No .: 57) may erroneously
appear even when the above problem is present, if the 4352B is operating in the heterodyne
mode and if the dierence between input signals from the device and the external signal
generator is larger than 40 MHz.
V erify that the DUT generates the proper signal, and sends it to the 4352B RF IN connector .
If the signal is generated, check its frequency . Press 4 Sense Range 5 ,
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
MAX TRANS FREQ or
NNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNNN
MIN TRANS FREQ , and the entry keys to change the detection bandwidth, if required.
57 RF Input Under Trans Min Freq
Indicates that the frequency transient measurement trace was probably inaccurate because the
input frequency to the 4352B was below the lower limit of the detection band.
Note , however , that \RF Input Under Trans Max Freq " (message No .: 58) may erroneously
appear even when the above problem is present, if the 4352B is operating in the heterodyne
mode and if the dierence between input signals from the device and the external signal
generator is larger than 40 MHz.
Messages-11